











In many vehicles, brake cooling is already recommended for medium loads, even off the racetrack.
This not only improves braking performance, but can also drastically reduce wear on the friction partners.
We use the channeling of the air flow to the center of the brake disc to utilize the turbine effect to cool the disc from the inside. In doing so, we direct the airflow at the disc at a specific angle in order to avoid scattering losses and make maximum efficient use of the available air volume.
Thanks to the lightweight construction in combination with powdered aluminum, the component is sufficiently strong and at the same time light and robust.
Your vehicle is not slow, that's a fact. However, this speed must be reduced as quickly as possible before cornering and this generates enormous heat. The ball joint of your control arm is extremely close to the hot brake disk and will be affected in the long term. This anchor plate therefore provides additional shielding for the bearing, thereby increasing its durability.
Scope of delivery:
Anchor plates for the front axle 1x left 1x right with connection for 51 mm air hose
(air hose + clamps not included, optionally available).
The anchor plate fits plug & play and no additional fastening material is required. The original fixing points and screws can be reused.
Suitable for:
E90/92/93 M3
E82 1 Series M