Aulitzky Tuning | Magnet licence plate holder | with approval

- with approval!
- Suitable for aluminium and 3D number plates!
- Super strong hold: one set of MagNFix achieves an adhesive force of over 64kg, which is more than other magnets!
- No scratches in the paintwork thanks to gentle Velcro over the magnets
- Super slim licence plate holder: only 3mm thick!
- One set = holder for one licence plate

Scope of delivery:
The set is for 1 licence plate (front or rear):
- 10 pairs of magnets (20 magnets with opposite polarity):
- 10 magnets for the licence plate
- 10 magnets for the bumper
- 1 Velcro sheet in the size 520 x 100 mm, can be cut to the licence plate length
- 2 alcohol swabs for degreasing
- Suitable pieces of film to cover the magnets behind the bumper
- Safety and application instructions
- Fitting and mounting instructions

Important: Is it permitted to attach the licence plates with magnets?
The Vehicle Licensing Ordinance (FZV) regulates who has to attach which licence plate and where.
According to §10 Paragraph 5 of the FZV, licence plates must be present and firmly attached to the front and rear of the vehicle. Neither the term "fixed" nor the type of attachment is defined in more detail. It is therefore not mandatory for the licence plate to be attached to the car with screws. Nor does the FZV preclude the licence plate from being attached with magnets.
In any case, it is important to follow the instructions for attaching licence plates with magnets exactly. Carefully attach the specified number of magnets to the bumper and licence plate.
Under NO circumstances should you use fewer magnets than specified or even use a set to attach one licence plate with magnets for two licence plates.
While driving, the licence plate is exposed to far greater loads and forces than when stationary. What is firmly attached in the car park can easily fly off while driving if you reduce the number of magnets.
The magnetic licence plate holder contains a total of 20 magnets for one licence plate. 10 magnets are attached to the inside of the bumper and 10 magnets to the back of the licence plate so that the licence plate remains firmly in place even at high speeds.

Notes on mounting:
Please be sure to observe the enclosed safety instructions! (in the data sheets tab)
Gluing the magnets to the licence plate:
When gluing the magnets to the licence plate, please ensure that the magnets
into the embossing (aluminium licence plates) or onto the rivets (3D licence plates).
licence plate. The magnet must be glued to a flat surface, otherwise the full adhesive force
the full adhesive force cannot be achieved.

MagNFix attachment step by step:
1. position the magnets on the inside and outside of the bumper and
Test positioning. Make sure that the magnets attract each other!
of the magnets!
2. mark the position of the outer magnets on the licence plate and thoroughly
thoroughly clean / degrease the relevant areas with the alcohol swab.
3. remove the protective film from the magnets and stick them to the licence plate. Press the
Press the magnets firmly onto the licence plate.
4. stick the licence plate fleece onto the licence plate, preferably starting at the top of the licence plate.
the top of the licence plate. First stick the licence plate fleece
first at the top, then peel it off completely and stick it downwards by
downwards. (An air cushion around the magnets is intentional and normal)
5. mark the position of the inner magnets on the bumper and mark the
thoroughly clean / degrease the relevant areas with the alcohol swab.
6. remove the protective film from the magnets and stick them to the bumper. Press the
Press the magnets firmly onto the bumper.
7. stick the film blanks onto the magnets. To do this, place the film on the magnet
and then press firmly from top to bottom. Here too, it is normal
air pockets around the magnet is normal. The magnets are protected by the film
from water and dirt.